Author Archives: graz27

On my refurb of a rusted ole AR Drone I obtained, I got a new set of bearings from Blade (BLH1607). These bearings I have used before and so I ordered some more to fit to these 4 rusted motors. … Continue reading →

I have thought this through a few times and its been about 4 years since I bought the AR Drone 2.0. Back then it was out just before DJI lanched it’s Phantom 1. So in 2012  the AR Drone caught … Continue reading →

Spent some time on this AR Drone 2.0 main board to see if it was repairable…. After checking over the main pcb, I have had the small ic U1700 (DMG4413LSS Mosfet) by the power in leads fail on more than … Continue reading →

Long time since I wrote anything on here , but anyways. My poor ole AR Drone 2.0 has been sitting in its box all broken for a while, although the main board worked mostly (except for the data line was … Continue reading →

Ever since I upgraded the firmware on this , it has seemed so much less stable. In fact it has a tendency to now and then, either shoot up high at take off or take off and hover low and … Continue reading →